Block magnets with a square base area and a countersunk hole. They can be fastened with a countersunk head screw. They are only 4 mm thick and therefore very discreet for hanging up signs, tools, etc. Especially suitable for cabinetmaking, kitchen installations, booth and store construction, signage technology, etc. We also carry round Pot magnets with countersunk hole screw-on.
Please note: Neodymium magnets are brittle and can break under excessive application of force. Therefore, we recommend a maximum tightening torque of 2 Nm when fastening this magnet.
The following screws fit into the hole of these magnets, for example:
- Countersunk wood screw with groove: DIN 97 (3,5 mm)
- Recessed countersunk flat head screws (machine screw): ISO 7046-2 M3 (3 mm)
- Countersunk torx screws (machine screw): ISO 14581 M3 (3 mm)
- Hexagon socket countersunk flat head screws (machine screw): ISO 10642 M3 (3 mm)