• Around 250 000 orders per year
  • Customer service in 3 languages
The product was added to your shopping cart.
Go to shopping cart

Hose on grinder

This hose stays where it is needed
Author: André H., Iserlohn, Germany
Online since: 07/08/2008, Number of visits: 329853
0
I work on a grinding machine. After each grinding process I need to rinse the grinding table. I did not have the opportunity to hang up the hose nearby.
Super magnets helped me to implement a new solution.
I used a standard cable tie and drilled a small hole into it.
Thereafter, I fit a M4 screw through the hole...
... and attached a pot magnet type TCN-16 to it.
Then, I attached the cable tie (e.g. Plastic cable ties 200 x 5,00 mm or Plastic cable ties 400 x 5,00 mm) to the end of the hose.
Now, I can easily hang up the hose on the machine. It sticks like a limpet :-)

The entire content of this site is protected by copyright.
Copying the content or using it elsewhere is not permitted without explicit approval.